Former 15" L7 converted to a 10" round sub.
D2, coil is rated to 1000 wrms, soft parts and motor will handle that without a problem. 6.6" Mounting depth
4 LAYER ROUND COPPER WIRE
Black Anodized Aluminum Former on Nomex Tape
1.75" WIND HEIGHT
3.60" FORMER HEIGHT
2.74" OUTER DIAMETER
2.58" INSIDE DIAMETER
Has not been powered since built! (Only very small amount of power to it to ensure it works and no coil rub).
Turned a 15" Kicker L7 motor into a round 10" with 12 spoke basket, triple spiders, firm cone, carbon fiber/kevlar 6" cap. It was a pain to make because I have to mill the basket to fit, trim the spiders, trim the cone, nothing fit right lol.
Only parts that were used previously here are the motor (obviously), and the rubber gasket.
4. Price: I would like to get $160 plus actual shipping. I have more money in it than that I just wanted to see if I could do this, and it was a success.
** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
This message is automatically inserted in all classified threads.
Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:
1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.
2) Name and address including postal code
3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.
DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.
If transaction was completed on CACO, please use iTrader to record feedback.
Potential buyers/seller should check iTrader feedback also before continuing transaction.
2003 6.8L V10 Excursion Limited
2015 MECA STREET 5 WORLD CHAMP