Car Audio Classifieds! banner

Matco muc12s mini screw driver

888 views 8 replies 3 participants last post by  Jeffhulbert50 
#1 · (Edited)
Matco muc12s mini power drill..great box builder

1. Product:

Matco muc12s screw driver mini drill

2. Specs:
12 mini screwdriver ... low/high speed...led light ...replaceable motor brushes

3. Description/Condition:

9.8/10 Cus it was used..no scratches/dings/dents
10/10 mechanical
Comes with case/manual/warranty card/ charger... only 1 battery

4. Price: :

250 shipped ...cost me 308.67 2 months ago from our local Matco guy... switched to a 1/4" impact

5. Pictures:















** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
-----------------------------------------------

This message is automatically inserted in all classified threads.

Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:

1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.

2) Name and address including postal code

3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.


DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.

If transaction was completed on CACO, please use iTrader to record feedback.

Potential buyers should check iTrader feedback also before continuing transaction.
 

Attachments

See less See more
9
#9 ·
It uses hex bits (very common in many tool sets)... I used a lil hex driver set with it that had a hex to 3/8 drive for sockets for light to medium duty nuts and bolts .. it'll drive a lag into a stud no problem... it has a quick change/release for swapping bits...u can also find drill bits with hex end for any drilling needs
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top