My little review and thanks to AQ..
I got my 10" recone in a week after I ordered it. Good fast service. I know I got lucky as you guys were out.
But I was happy.
So I got the recone, took apart my AQ HDC3 18" come to find out it only has a bolt pattern for the 18" in it.. So we moved to my 15" HDC3 that we just blow on a stetsom 7k.. But I must say for copper it took a beating hard and 2 comps on a 7k putting out about 4k because we turned it way down. LoL
So I got the recone, noticed I lost my activator for my PSI ca glue. I said screw it, come to find out it leaves a white residue if you don't use the activator. It's not that bad ( see photos ) butI am trying to figure out how to get it off. It whips right off the motor but it seems to like the powder coat a little better and is being a little hard to get off. Any ideas?
I must say this thing is VERY VERY STIFF. I can pick it up by the cone and it does not move. LoL
Couple of questions.
1. Where the leads are tied down it seems the spider is trying to come up right there where it goes in to the spider will this affect anything?
What I am talking about is just to the left of the positive the edge of the spider is like coming up, on the other side. I need to get a photo of that side but here is the other side.
Here is my glue issue due to no activator. Any ideas how to get this off safely with out hurting the basket?
Ok here is a few more images, dust cap not on yet due to the activator issue. LoL
Just sizing it up.
I will get some photos of it with big uncle Sundown Night Shade 10" D2 tomorrow.