Alright guys. Got a deal on a JL 500/5 that I was going to resell, but decided that I would rather use it. Upon installation, I found that the front channels aren't working right...
A little info on the amp:
Picture to help clarify everything is on page 2 of that PDF file.
Here is a run down of what happened, and how I tested everything:
-install everything, wires ran, hooked up, ready to test.
-sub channel is working, tuned it, looks good.
-rear channels are working fine (the 25w channels)
-fronts not working....
-swap RCA's out with the one's for the rears, still no sound.
-If I switch the HPF to OFF or High Pass I get very faint music at any gain/volume, and some static.
-If I switch the HPF to Bandpass it goes dead again.
(To help clarify the amp is set up so that the HP on the rear channels acts as the cut off for the BP on the front channels)
Hope there is enough info here for someone to help me diagnose the issue. I REALLY want this amp to work out. Got a good deal on it, and the sub and rear channels are working great for me. IF I end up selling it, I want to be able to sell it fully functional.