AQ HDC3 15 in my Silverado!

[jon_hawley]

Wiring is a joke, soon to be replaced by all shca or knu, havent decided yet.. This is my first "real" build, everything was done by me, really happy with it so far but im sure itll all be replaced soon haha..

Equipment:
AQ HDC3 15 d2
Power acoustik BAMF 4k ("4k" )
Stinger SPV44 with Stinger isolator
Embarrassing wiring

Stuff made out of wood:
Box: 4.66cu^ft net, 2 4" aero ports firing towards rear of cab, underneath the seats, tuned to 32hz
Amp/battery rack

[jon_hawley]

Pictures didn't come up right.. sorry guys, im new on here!

[tat2bass]

I'm seeing more and more people running the power acoustic bamf amps. How close do they come to putting out rated cleanly?

[72impala]

If you want, pm me and I'll give you some tips and such to make that cleaner. I took out that single seat, built a false floor, then put a single 15" on the false floor in place of that single seat. The box is a wedge so the passenger seat leans up against it perfectly. Also the battery can go under the false floor (I fit an nsb110 under it).

Good thing about yours is you can probably remove it easier. Mine is damn near permanent now with everything bolted down.

[dirt101]

I had a very similar setup in my dads f150 when i was driving it. Bamf 5500 and an hdc315. I chose to set it up in the center seat.

[jon_hawley]

Honestly, the claimed 2200w @ 1ohm is never gonna happen, it only has 3 40a fuses.. i think on 14.4v its somewhere around 1800w, but i picked it up for 90 bucks so no complaints here. And thanks impala but im hopefully selling this truck soon to get a bike and an ext cab ranger or s10! it needs a lot of work to make it clean but the whole install only took me probably 12 hours start to finish (including box building and wiring and whatnot)