zed audio leviathan lll
Rated power is 190 watts x 6 into 4 ohm or 300w x 6 into 2 ohm.
Bridged power is 380w x 3 into 8 ohm or 600w x 3 into 4 ohm.
The 3 pairs of channels are independently bridgeable.
Two, four or six input configuration.
Channels 1+2 feature a 24dB per octave Linkwitz Riley High crossover.
Channels 1+2 can run in FLAT mode (Pre-amplifiers completely bypassed), High Pass or Low Pass from channels 5+6.
Channels 3+4 feature 24dB per octave Linkwitz Riley High and Low Pass crossovers.
Channels 3+4 can run in FLAT mode (Pre-amplifiers completely bypassed), High Pass, Low Pass or Bandpass or Low Pass from channels 5+6. .
Channels 5+6 feature feature 24dB per octave Linkwitz Riley High and Low Pass crossovers.
Channels 5+6 can run in FLAT mode (Pre-amplifiers completely bypassed), High Pass, Low Pass or Bandpass.
The High Pass crossover doubles as a subsonic filter as it is able to respond down to 10Hz.
nib, amp was tested but not used or installed this came in straight from zed . also i had steve internally add a pin so amp can be ran 3 way active off 2 rcas . this can be reversed just by taking jumper pins off it can be done on the outside as well just have to jump 1,3,5 and 2,4,6 rcas together . i figured steve is alraedy assembling the amp and it does look nicer rather than having a bunch of rca
725.00 shipped firm con u.s
** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
This message is automatically inserted in all classified threads.
Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:
1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.
2) Name and address including postal code
3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.
DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.
If transaction was completed on CACO, please use iTrader to record feedback.
Potential buyers/seller should check iTrader feedback also before continuing transaction.