a/d/s p850.2 8 ch. Powerplate amplifier
watts/ channel 4 ohm: 50x8
watts/ channel 2 ohm: 75x8
watts/ bridged 4 ohm: 150x4
THD: < 0.10%
S/N ratio: &90dB
damping factor: &150
input sensitivity crossover frequency/ slope: 100mV to 10V 45-5kHz/ 12dB
dimensions: 330mm x 50mm x 410mm
8 channels of clarity & adjustability multiple crossover points to run components actively! It was just tested in my fusion yesterday & my goodness, it was night & day compared to the old school fosgate 4 ch. in there. I would keep it but I am not so much of an audiophile, I would rather have other stuff. There are a couple plugs missing that are $8 on ebay or you could use female bullet connectors on your speaker leads. The power wires have been soldered directly to the connectors on the amp (unsolder if you want). It works flawlessly every knob & potentiometer & button on the controls works.
$600 or partial trade/ paypal
** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
This message is automatically inserted in all classified threads.
Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:
1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.
2) Name and address including postal code
3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.
DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.
If transaction was completed on CACO, please use iTrader to record feedback.
Potential buyers/seller should check iTrader feedback also before continuing transaction.