1. Product: JL Audio e6450 6 Channel Amp
Measured Power (CEA-2006 Standard):
72.7 Watts x 6 into 4 ohms; 107.8 watts x 6 into 2 ohms; 215.5 watts x 3 into 4 ohms
Sub Channel only (Channels 5 & 6 at 50 Hz):
107.6 watts x 2 into 4 ohms; 181.6 watts x 2 into 2 ohms; 363.3 watts x 1 into 4 ohms
vSignal-to-Noise (CEA-2006 Standard):
IDLE/MAX Current Draw:
1.9 amps/76 amps
60% @ 2 ohms stereo all channels driven 1/3 Efficiency
25% at 2 ohms all channels driven
Recommended Fuse Value:
Recommended Fuse Type:
AGU, AFS or MaxiFuse
No. of Inputs:
Three Stereo Pairs
Differential, noise-canceling with RCA jack inputs
200mV - 8V RMS
Class AB with patented Absolute Symmetry dual N-Channel MOSFET output design
Unregulated MOSFET switching type
Rated Power (Stereo):
45 watts RMS x 6 @ 4 ohms. (12.5 volts); 75 watts RMS x 6 @ 2 ohms. (12.5 volts)
Rated Power (Bridged):
150W RMS x 3 @ 4 ohms. (12.5 volts)
THD at Rated Power:
less than 0.08% @ 4 ohms per channel
(20 Hz - 20 kHz)
greater than 104 dB referred to rated power (A-weighted, 20 Hz-20 kHz noise bandwidth)
10 Hz-25 kHz (+0, -1 dB)
State-variable, high-pass or low-pass 12dB/octave Butterworth with continuously variable cutoff frequency selection from 50-200 Hz (Defeatable).
DIMENSIONS (L x W x H):
17.7- x 9.25- x 2.36-inches (450 mm x 235 mm x 60 mm)
3. Description/Condition: Used for a short time with low power output. Like new condition.
: 300 + Ship. Will also trade for a Sundown Amp or a 2K+ Amp.
** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
This message is automatically inserted in all classified threads.
Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:
1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.
2) Name and address including postal code
3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.
DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.
If transaction was completed on CACO, please use iTrader to record feedback.
Potential buyers/seller should check iTrader feedback also before continuing transaction.