I've done some research but i must admit i'm LOST.
I've got an idea i'm milling around that could possibly be huge, and it'd start off with a website and a sticka maka.
I know there's quite a few people on here with vinyl cutters/plotters (spy, gboo, derrick)
I'd only need it for cutting single color decals, so i don't need a fancy rig. If it'll cut good, clean lines then it'll be more than sufficient for me.
Right around the 24" range would be fine.
My question is (to anyone with experience) what do i need, as far as equipment? I don't mind the bare minimum, because i don't want to get too deep into this idea and it be a wash.
What is a decent machine? What kind of prices am i looking at?
I'm genuinely devoted to this idea, so any help is really appreciated.