assembled jig for pulling subwoofer parameters via LIMP software
line in (mic) , line out (headphone) 3.5mm cords and a + (red) - (white) wire for speaker connection
1 = test mode with the built in resistor (do not hook speaker up)
2 = t/s mode (meaning hooked leads to speaker ready to pull parameters
this jig was my assembly tester. thusly, its 100% functional and flooded in glue inside for reliability. the case however was a tester (so its a bit ugly/ruff) and has simple pin leads for the speaker which can be swapped BUT NOT LENGTHENED later if preferred. the production ones will be alligator clip and wire
** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
This message is automatically inserted in all classified threads.
Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:
1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.
2) Name and address including postal code
3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.
DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.
If transaction was completed on CACO, please use iTrader to record feedback.
Potential buyers/seller should check iTrader feedback also before continuing transaction.