a plexiglas bottom plate i made for one of my aq 2200ds.
fits aq 2200d
in good condition no scratches or anything looks great on the amp. only issue is this was one of my prototypes i made and since it is etched on the reverse side so that the part you can see and touch is smooth and the etching will light up better, i forgot the reverse the letters on the little logo on the bottom right. i just covered it up with the beauty panel and no one ever knew
: 20 plus shipping obo
** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
This message is automatically inserted in all classified threads.
Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:
1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.
2) Name and address including postal code
3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.
DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.
If transaction was completed on CACO, please use iTrader to record feedback.
Potential buyers/seller should check iTrader feedback also before continuing transaction.
Headunit: Alpine 9885
Highs: 2 cresendo xst2 super tweeters
Mids: 2 sets of elemental designs 6.5s
Highs amp: O/S Rockford 160.2
sub: kove audio w 12 (temp Sub)
Sub amp: American bass VFL 100.1
wiring: knu konceptz 1/0