Car Audio Classifieds! banner

Mmats sq4100 (mint)

2137 Views 4 Replies 3 Participants Last post by  onelivinlarge
1. Product:

2. Specs:
POWER @ 13.8 Volts:
RMS @ 4 ohms stereo - 4 X 100
RMS @ 2 ohms stereo - 4 X 110
RMS @ 4 ohms mono - 2 X 220
Idle Current: 1 amp
Signal to Noise Ratio A-Wtd: <100dB
Total Harmonic Distortion: 0.04%
Channel Separation: <80dB
Input Sensitivity: 150mV-5V
Slew Rate: 15V / Usec
Fuse Rating: 30 amp
Height: 2.25”
Width: 9.5”
Length: 13.375"
General Information:
Frequency Response: <10Hz to 22KHz
Lowpass Filter: Variable 24db, 60 to 360Hz
Crossover: Lp / Hp / Off
Battery Connetors: 4 Gauge
Speaker Connectors: 8 Gauge
Toshiba audio-grade outputs
High current connectors
Independent gain controls
24db variable crossover

3. Description/Condition:
10/10 cosmetically
10/10 mechanically
I got this amp brand new. Was used for two weeks.
Paid $650.00 for it 5 weeks ago.
4. Price: :
$500.00 shipped in the U.S. OBO.
Or trade

5. Pictures:


This message is automatically inserted in all classified threads.

Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:

1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.

2) Name and address including postal code

3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.

DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.

If transaction was completed on CACO, please use iTrader to record feedback.

Potential buyers/seller should check iTrader feedback also before continuing transaction.
See less See more
1 - 5 of 5 Posts
Price change. No one has any intrest in a great amp?
Lots of people looking... No one wants to make any offers?
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.