Car Audio Classifieds! banner

single 9515 in a supercrew truck, need opinions on box design

2264 Views 85 Replies 8 Participants Last post by  bigdhenderson
first off, dont laugh. Im horrible at anything CAD....so heres a couple ideas so far, still need to run the numbers though...

Attachments

See less See more
2
1 - 20 of 86 Posts
i think im liking the slot port idea better....port would pretty much be pointing right at my rear window in that postion
My vote goes for the aeroport idea. 2 6" would work also
ive only got the 8" port layin around to use tho...
heres a pic of the spot the box will be going in, this pic was taken during the process of re-doing my rear seats, which have been done for a while now.
well the pic i want to load wont work for some reason so heres a pic of a prefab box i had in for a temporary setup..obviously it was way too big and looked like hell

Attachments

See less See more
heres the design im pretty much settled on...anyone care to chime in? see any design flaws with it? Can someone calculate the net volume for it? sub displacement is .24, im gonna want about 18-20 inches per cube of port with around a 40hz tune

Attachments

See less See more
one last edit to what I want

Attachments

See less See more
is this in the wrong forum or something?
I like this one
See less See more
no haha, people are just slow here lately. I honestly have no idea what it is you are trying to do. But i have been looking into a crew cab 05 f150 and was hoping it would give me and idea but is that the harley Davidson edition, so you have the captain chairs in the back?
me too, but after looking at it more i wont have the depth to do the aero in that location
no haha, people are just slow here lately. I honestly have no idea what it is you are trying to do. But i have been looking into a crew cab 05 f150 and was hoping it would give me and idea but is that the harley Davidson edition, so you have the captain chairs in the back?

nope, rear bench...well it was....i took the 60 bench section and made it match the 40 side. seats still flip up like normal and everything...alot of fabrication involved and I have a good (and cheap) upholstery guy
oh i suck at reading, are those seats custom? i personally like the aeroport desogn better also.
two 4" ports would work on the same plane as the woofer
they would be shorter and take up less airspace while doing the same job.
nope, rear bench...well it was....i took the 60 bench section and made it match the 40 side. seats still flip up like normal and everything...alot of fabrication involved and I have a good (and cheap) upholstery guy
Very nice, i would like to see more pictures of it, i want a crew cab but not much room for a system. So i may end up with an extra cab.
what are your max dimensions? I will throw a few designs together, my designs aren't the most accurate but will help much better than this.
i bought a whole rear seat setup out of an f150 and did some chopping both to it and my factory seats to make this whole setup work

Attachments

See less See more
i bought a whole rear seat setup out of an f150 and did some chopping both to it and my factory seats to make this whole setup work

oh wow, way more work than i would wanna do. plus i have no experience with fabricating.
17.5" between the seats is max width, 29" tall to the bottom of the window line, and depth is max of 33 but I want to keep it no more than 22 so i can still put my front seats back a ways
1 - 20 of 86 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top