Car Audio Classifieds! banner

Status
Not open for further replies.
1 - 17 of 17 Posts

·
Registered
Joined
·
1,530 Posts
Discussion Starter · #1 ·
1. Product: Sundown sax 125.2



2. Specs:

2/1 Channel Bridgeable Class-AB Amplifier
MOSFET PWM Power Supply
Stable Into 4 Ohms Bridged or 2 Ohms Stereo Load
12dB Octave Electronic Crossover Slope
Variable Subsonic Filter
High Pass Filter Variable with x 10 Range Selectable Switch
Low Pass Filter Variable with x 10 Range Selectable Switch
HPF/FULL/LPF Selectable Switch
Variable Bass Boost Control
Variable Bass-Boost Frequency Control
Variable Input Level Control
Input Sensitivity : 200mV ~ 6V
Subsonic Filter : 10Hz ~ 500Hz
Signal Input and Line Out RCA Connectors
Multi-Way Protection circuitry (Thermal/Over Current/Speaker Short/Speaker DC protection)
Tested Voltage & THD: 14.4V & Less than 0.05% THD
Operating Voltage : DC10V~16V Power Input
Wired Remote Controller
MSRP $349 USD

Rated power output
----RMS power, 4 ohm stereo
125W x 2CH
----RMS power, 2 ohm stereo
200W x 2CH
----RMS power, 4 ohm bridged
400W x 1CH
Signal to Noise Ratio >90dB
Low pass frequency crossover 50Hz ~ 5KHz
High Pass Crossover 30Hz ~ 3KHz
Variable Subsonic Filter 10Hz to 500Hz
Bass Boost 0~18dB
Variable Bass-Boost Frequency Control 35Hz to 120Hz
Frequency Response 10Hz ~ 40KHz (+/-1dB)
[email protected] Watts <0.1%
Channel Separation 75dB
Fuse Rating 20A x 3
Input Sensitivity Variable 200mV~6V (+/- 5%)
Dimensions 252(W) x 58(H) x 340(L)mm




3. Description/Condition: Used, excellent condition. 9.5/10 cosmetically small scratch on heat sink and 10/10 function



4. Price: $150 shipped: NO BEST OFFERS:FIRM ON PRICE:TRADE=sax100.4 + cash on my end



5. Pictures:















** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
-----------------------------------------------

This message is automatically inserted in all classified threads.

Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:

1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.

2) Name and address including postal code

3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.


DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.

If transaction was completed on CACO, please use iTrader to record feedback.

Potential buyers/seller should check iTrader feedback also before continuing transaction.
 

Attachments

·
Premium Member
Joined
·
3,842 Posts
nice amp, If you were takin other trades i would offer GLWS.
 

·
Registered
Joined
·
1,530 Posts
Discussion Starter · #4 ·
PM me w/offers, maybe something you have will stand out. I'm REALLY looking for 100.4, but can use some other things.
 

·
Registered
Joined
·
1,577 Posts
awesome amp, I just recently bought a brand new then had to sell it like a week later due to bills, I really miss it. GLWS bro, hell of a price!
 

·
Registered
Joined
·
1,530 Posts
Discussion Starter · #8 ·
awesome amp, I just recently bought a brand new then had to sell it like a week later due to bills, I really miss it. GLWS bro, hell of a price!
Thanx. I thought I'd try and price it for a quick sell so I could pick up a 100.4. If no one scoop it up soon, I'll just grab a second one for the 2nd set of comps.
 

·
Premium Member
Joined
·
3,842 Posts
Thanx. I thought I'd try and price it for a quick sell so I could pick up a 100.4. If no one scoop it up soon, I'll just grab a second one for the 2nd set of comps.
y not just run each channel at 2 ohms? Thats what im doing. basically one door/pillar per channel.
 

·
Registered
Joined
·
1,530 Posts
Discussion Starter · #10 ·
y not just run each channel at 2 ohms? Thats what im doing. basically one door/pillar per channel.
As of now, that's exactly what I'm doing. The front doors are on one channel and the back doors are on the other. I want each door to have its own channel. That's why I want to go w/the 100.4 or another 125.2 (if this one does not sale). To top it off, my comps are 2ohm w/o having to series or parallel them.
 
1 - 17 of 17 Posts
Status
Not open for further replies.
Top